The Teledyne series 7600 can also be supplied with an oxygen sensor, providing the operator with a space-saving, five in one, cost-effective design.
Process Analyser Systems launch Teledyne's series 7600 infrared (IR) gas analyser.
The model 7600 is capable of detecting up to four chosen, individual IR absorbing components (i.e.
NO, SO2, CO2, CO, and CH4) on a continuous basis.
Conveniently packaged in either a 19inch rack mount or Nema-4 wall mount enclosure, the series 7600 can also be supplied with an oxygen sensor, providing the operator with a space-saving, five in one, cost-effective design.
The Nema-4 enclosure can be purged to satisfy hazardous area installation requirements.
Simultaneous measurement of up to five components.
Excellent long-term stability.
Large, easy to read LCD display showing all simultaneous measurements and computations.
Slide-out, chassis design to facilitate any optical or maintenance adjustments required to fine tune analyser performance (7600A).
In-depth, valuable analyser functions attainable from the front-panel user interface buttons.
Follow and Hold output signal control (during calibration).
Remote range change control.
Low / Hi limit alarms.
Range ID signals.
Auto-calibration with user adjustable frequency and gas flow time setting programming capabilities.
Remote auto-calibration initiation.
Auto-calibration status contacts.
Instrument or calibration error contact outputs.
Extra functions included such as average value computation, O2 conversion.
Options.
Percent O2 detector - paramagnetic (built-in) or ZrO2 (externally installed), user preference.
O2 correction (the conversion of measured CO and SO2 readings into values at standard O2 concentration).
Consult factory for more detail of functionality.
Communication functions:.
RS-232C (9 pins D-Sub connector).
Half-duplex bit serial.
Modbus protocol.