Improved method development versatility with Micromeritics 3Flex - analyse three samples simultaneously each with its own adsorptive.
A requirement of any method development process is the ability to efficiently apply various investigational conditions to a sample to determine the optimal experimental parameters for increased resolution, accuracy, and characterisation.
Recent design improvements make the Micromeritics 3Flex the only surface characterisation analyser currently able to analyse three samples simultaneously, each with a different adsorptive, the company claims.
The high-performance 3Flex vacuum system coupled with minimal system volumes allows for rapid gas supply changes while maintaining superior levels of cleanliness.
This design advantage, along with full software control, delivers the ability to apply a different adsorptive to each of the three sample ports in a single analysis run with no system/sample contamination or bleed.
The method development chemist can now efficiently apply different run parameters during development to determine the best operating approach to maximise desired results.
Additional design advantages support this new instrument feature. Each analysis port is upgradeable from mesopore to micropore with its own transducers.
Servo control for dosing and evacuation provides a higher degree of gas management and speeds the collection of data points through reduction of dosing overshoot.
Pneumatically actuated, hard seal valves provide ultra-clean, leak free instrument operation.
Stainless steel gas inlets, VCR fittings, manifold, and gaskets eliminate interference from contaminates and outgassing associated with elastomer seals and O-rings.
These chemically resistive surfaces also allow the use of a greater selection of adsorptives. Intuitive MicroActive for 3Flex software gives the user the ability to interactively evaluate isotherm data and reduces the time required to obtain surface area and porosity results.
